1.高效過濾器包裝外包裝盒完好無損無破損,無碰撞、裂開的印痕;包裝(包裝袋)密封性應完好無損,泡沫塑料角、保溫泡沫板應齊備,型號規格、排風量、氣旋流入等標志應詳細、精確、齊備,有商品產品合格證等.
1. the packing box of high efficiency filter package is intact, no breakage, no collision and split. The packing (packing bag) should be intact. The foam plastic angle and insulation foam board should be available. Models, specifications, exhaust volume and cyclone inflow should be detailed, precise and complete, and have product product qualification certificate.
2.架構高效送風口架構表層無顯著環境污染,無凸凹、傷疤,無刮痕、鍍層,無脫落,無毛邊,銹跡;高效送風口架構(粘密封膠條一邊)應整平,無顯著誤差;高效送風口架構抗壓強度應符合規定,如放到整平的表層,晃動,架構無形變、
2. The surface layer of the structure of efficient air supply outlet has no significant environmental pollution, no bumps, scars, scratches, coatings, no shedding, no hairy edges and rust marks; the structure of efficient air supply outlet (one side of the sticky sealant strip) should be leveled without significant error; the compressive strength of the structure of efficient air supply outlet should meet the requirements, such as on the leveled surface, shaking, invisible change of the structure, and no significant error.
3.接縫處高效送風口過濾紙和架構中間的密封性應嚴實,沒有間隙和孔眼;高效送風口和架構中間的窗戶密封條,應聯接、無破裂狀況,看著整平,高效送風口和架構中間的窗戶密封條的薄厚不適合超出8mm,壓縮率為25%-30%.
3. Sealing between filter paper and structure of high-efficiency air supply outlet at joint should be strict, with no gap and hole. Sealing strip of window between high-efficiency air supply outlet and structure should be connected and without rupture. Looking at leveling, the thickness of sealing strip of window between high-efficiency air supply outlet and structure is not suitable to exceed 8mm, and the compression rate is 25%-30%.
4.濾紙單面折紙層數符合要求,紙隔板的高度應在4.0-4.5mm之間;濾紙無損傷、無污損、無脫屑、無皺褶、無打膠、無補丁;分隔板無明顯損傷,平齊均勻;密封膠整齊、無裂紋,濾紙和分隔板浸潤高度不大于5mm,框架濾紙和密封膠粘帖處,不應出現裂紋、氣泡,孔洞和皺褶現象.http://www.696954.cn
4. The number of folding layers on one side of filter paper meets the requirements, and the height of the separator should be between 4.0 and 4.5mm; the filter paper should be non-damaged, non-stained, non-chipping, non-wrinkling, non-gluing and non-patching; the separator has no obvious damage and uniformity; the sealant is neat and non-cracked, the wetting height of filter paper and separator is not more than 5mm, and the filter paper and sealant paste of the frame are at the same time. Cracks, bubbles, voids and wrinkles should not occur.